Cylindrical Type Manganese Dioxide Lithium Batteries
Characteristic | Primary Batteries
- Thin positive electrode materials, mainly comprising manganese dioxide, are wound in a spiral form around thin metallic lithium layers, which serve as the negative electrode, with special porous separators between them.
- The nominal voltage of single lithium batteries 3V, about the double that of conventional dry batteries.
- Spiral electrode structure ensures high-drain current discharge.
- The annual self-discharge rate at room temperature is 1% or less.
- These batteries can be used under an extremely wide range of temperature(-20°C ~ +60°C ).
- Flat and stable operating voltage throughout the discharge life.
- Excellent leak resistance.
- Best suited for fully automatic cameras.
Characteristic
| Model No. | CR2 | CR123A | 2CR5 | CR-P2 |
|---|---|---|---|---|
| Nominal Voltage(V) | 3 | 3 | 6 | 6 |
| Nominal Capacity(mAh) | 850 | 1400 | 1400 | 1400 |
| Dimensions (mm)(Max.) |
 |
 |
 |
 |
| Weight(g) | 11 | 17 | 40 | 37 |
| Usable Temperature Range |
-20°C ~ +60°C | |||
These batteries contain combustible materials such as lithium, organic solvent, etc. By misuse, this may cause battery leakage, heat, explosion or ignition, bringing, about injury or apparatus failure. So, observe strictly the following matters.
- Only use these batteries for specified use.
- Do not recharge, short-circuit, disassemble, deform, heat above 212°F or incinerate.
- Do not insert batteries in reverse polarity.
- Keep batteries out of reach of babies and little children. If by any chance, the batteries are swallowed, consult a doctor immediately.
- Do not connect (+) (-) of the batteries with wire and do not carry or keep metallic necklace, hairpin, etc. together with batteries.
- Do not peel off or damage the outer label of the batteries.
- Do not mix and use " different types of batteries" nor "used and new batteries" together.
- Do not solder directly to the batteries.
- Do not drop the batteries or expose them to strong impact, and do not deform the batteries.
- At storage or disposal of the batteries, insulate the terminal parts with tape or the like.
